Wang, P; Zangeneh, M; Richards, B; Gray, K; Tran, J; Andah, A; (2018) Redesign of a Compressor Stage for a High-Performance Electric Supercharger in a Heavily Downsized Engine. Journal of Engineering for Gas Turbines and Power , 140 (4) , Article 042602. 10.1115/1.4038021.

Text gtp_140_04_042602.pdf - Published Version Access restricted to UCL open access staff Download (4MB)

Abstract

Engine downsizing is a modern solution for the reduction of CO2 emissions from internal combustion engines. This technology has been gaining increasing attention from industry. In order to enable a downsized engine to operate properly at low speed conditions, it is essential to have a compressor stage with very good surge margin. The ported shroud, also known as the casing treatment, is a conventional way used in turbochargers to widen the working range. However, the ported shroud works effectively only at pressure ratios higher than 3:1. At lower pressure ratio, its advantages for surge margin enhancements are very limited. The variable inlet guide vanes are also a solution to this problem. By adjusting the setting angles of variable inlet guide vanes, it is possible to shift the compressor map toward the smaller flow rates. However, this would also undermine the stage efficiency, require extra space for installing the inlet guide vanes, and add costs. The best solution is therefore to improve the design of impeller blade itself to attain high aerodynamic performances and wide operating ranges. This paper reports a recent study of using inverse design method for the redesign of a centrifugal compressor stage used in an electric supercharger, including the impeller blade and volute. The main requirements were to substantially increase the stable operating range of the compressor in order to meet the demands of the downsized engine. The three-dimensional (3D) inverse design method was used to optimize the impeller geometry and achieve higher efficiency and stable operating range. The predicted performance map shows great advantages when compared with the existing design. To validate the computational fluid dynamics (CFD) results, this new compressor stage has also been prototyped and tested. It will be shown that the CFD predictions have very good agreement with experiments and the redesigned compressor stage has improved the pressure ratio, aerodynamic efficiency, choke, and surge margins considerably.

Download activity - last month

Export as XMLCSVJSON

Download activity - last 12 months

Export as JSONCSVXML

Downloads by country - last 12 months

Export as XMLCSVJSON

Archive Staff Only

View Item